Model V-1500-I-LB

Model V-3000-I-LB

Maximum Capacity

1,500 lbs.

3,000 lbs.

Table Size

22” x 36” (or sized to fit)

72”L x 22”W (or sized to fit)

Top

Lift Bar

Lift Bar

Height

24” (or to customer specifications)

24” (or to customer specification)

Vibrator (s)

1-Phase, 480-Volt, 60-HZ, 3600 CPM

1-Phase, 480-Volt, 60-HZ, 3600 CPM

Lift Bars

5/8” x 8” Steel

5/8” x 8” Steel

Air Bags

Four at 850-lb. Capacity Each

Six at 850-lb. Capacity Each

Number of Output Forces

Infinite

Infinite

Number of Vibrators

One

Two

Timer Starter

Included

Included

Timer Starter Enclosure

Remote

Remote

The rugged steel frame is fabricated from integrally interlinked 1/2" steel plate. The lift bar assembly is fabricated from 5/8” x 8” steel with an interlocked rib system welded solid to a 5/8" steel base plate.

The lift bar assembly is actuated by pneumatic air bags, each with a capacity of 850 lbs. and a maximum stroke of 2”. In the elevated position, the lift bars extend above the roller conveyor approximately ½”.  (figure 1)

Vertical Vibrators 

The vertical vibrators are used to obtain the optimum compact ability of molds and cores. The vibrators provide an infinitely adjustable level of output force while maintaining the high frequency that is critical for the correct no-bake compaction.  (figure 2)

Controls

All vibrator controls and time relays are housed in NEMA 12 enclosures. (figure 3)

The cycle start button and the force selector rheostat are located at the operator control box.  (figure 4)

Operation 

The mold/core box is rolled onto the table rollers and filled. Prior to striking off, the operator presses the cycle start button. The air bags inflate, lifting the core/mold above the rollers the vibrators run the amount of time set on the timer located inside the enclosure. Once the vibrators stop, the air bags lower the core/mold to roller conveyor surface for striking off. (figure 5)

Options

• Flat Top
• Manual Conveyor
• Powered Conveyor

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5